Alexor PC9155D-433 Guia de Instalação descarregar pdf (Página 20)

PC9155 Wireless Alarm System

3-4

[][7][1 or 2] – Command Outputs (1&2)

Press [][7] then [1] or [2]. If the Command Output Code Required option is enabled, enter a valid user code. The panel activates a command out-

put assigned to any PGM.

[][8] – Installer Programming

Press [][8][Installer Code] to enter Installer Programming. Installer programming allows the installer to program all system functions.

Refer to the section 5: Installer Programming for details.

[][9][User Code] – No-Entry Arming

Press [][9] followed by a valid user code. The system arms in the Stay mode after the exit delay expires and removes entry delay. All zones pro-

grammed as Delay function like Instant zones. The system flashes the Armed light to indicate that it is armed with no entry delay.

[][0] – Quick Arm/Quick Exit

Quick Arm: When disarmed, press [][0] to arm the system. Quick Arm is equivalent to entering your user code.

Quick Exit: When armed, press [][0] to activate Quick Exit. Quick Exit allows you to exit the premises without disarming the system.The sys-

tem allows a single zone programmed as Delay to be violated and restored once during the following 2 minute time period without changing the

status of the system.

3.4 Function Keys

The keypad has 5 programmable one-touch function keys located in a column down the right-side of the keypad. These keys can also be activated

by pressing and holding number [1] through [5] respectively for 2 seconds. The default for these keys are as follows:

[1] Stay Arm [4] Bypass

[2] Away Arm [5] Quick Exit

[3] Chime Enable/Disable

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 87 88

Sem comentários

Alexor PC9155D-433 Guia de Instalação Página 20