Alexor PC9155D-433 Manual do Utilizador

N11427IMPORTANT: This manual contains information on limitations regarding product use andfunction and information on the limitations as to liability

6Trouble ConditionsWhen a trouble condition is detected, the Trouble ( ) indicator will turn on and the keypad willbeep every 10 seconds. Press the

7Access Code ProgrammingIn addition to the master code, you can program up to 16 additional user access codes. If wire-less keys have been programmed

8to have this programmed. The Master code cannot use the Bell/Siren Squawk attribute, but thecode is required to enable the Bell/Siren for other codes

9User Function CommandsDisarm the system then enter [Master Code]. The command is used to gainaccess to the following list of Master functions of

10Late to OpenThis features allows a user to be notified if their alarm system is not disarmed by a programmedtime of day.NOTE: The Late to Open featu

11WT4989/WT8989 Status Display IconsThe table below summarizes the status that can be shown by the WT4989/WT8989 LCD:BuzzerProvides an audible confirm

12WT4901/WT8901 Siren Battery TestTo determine which siren has a low battery press and hold the test button, located at the front of the siren, for 5

13If you suspect a false alarm signal has been sent to the central monitoring station, call the station to avoid an unnecessary response.Access CodesM

14Keypad Quick GuideStatus LightsReady - must be on to arm system. All zones must be secured or bypassed and the system disarmed for this light to act

15Guidelines for Locating Smoke & CO DetectorsThe following information is for general guidance only and it is recommended that local fire codesan

FCC COMPLIANCE STATEMENTCAUTION: Changes or modifications not expressly approved by Digit-al Security Controls could void your authority to use this e

16Smoke detectors should always be installed in USA in accordance with Chapter 11 of NFPA 72,the National Fire Alarm Code: 11.5.1.1 Where required by

17Household Fire Safety AuditRead this section carefully for important information about fire safety.Most fires occur in the home. To minimize this da

IMPORTANT - READ CAREFULLY: DSC Software purchased with or without Products and Componentsis copyrighted and is purchased under the following license

WARNING Please Read CarefullyNote to InstallersThis warning contains vital information. As the only individual in contactwith system users, it is your

iTable of ContentsAbout Your Security System 1Fire / CO Detection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

iiAlways ensure you obtain the latest version of the User Guide. Updated versions of thisUser Guide are available by contacting your distributor.IMPOR

1About Your Security SystemRead this manual carefully and have your installer instruct you on your system's operation andon which features have b

2Keypad Controls & IndicatorsIMPORTANT NOTICEA security system cannot prevent emergencies. It is only intended to alert you and your centralstatio

3When the interior zones are activated (i.e., ) you must enter your access code or pres-ent your proximity tag to disarm the system in order to gain

4Remote Arming and DisarmingThe system can be armed and/or disarmed, if programmed by the installer, using a remote controldevice (wireless key fob).

5Bypassing ZonesUse the zone bypassing feature when you need access to a protected area while the system isarmed, or when a zone is temporarily out of